Thingiverse
Tools
Model downloaden
Hex bit handle and stand
410
Downloads
332
Likes
2
Makes
Two handles (one with a long shaft/hole and one with a short one) and a stand for use with hex bits (6x4mm sides). The stand holds two handles and 48 bits
This was my first "real" project in FreeCAD, and it turned out better then i thought it would :-)
I use it regularly, so for me it was a good "build".
It might be useful to glue or embed a small flat magnet in the handle. I didn't, but next time i think i will... The hexbits can sit a bit loose inside the handle sometimes.
This was my first "real" project in FreeCAD, and it turned out better then i thought it would :-)
I use it regularly, so for me it was a good "build".
It might be useful to glue or embed a small flat magnet in the handle. I didn't, but next time i think i will... The hexbits can sit a bit loose inside the handle sometimes.
blok82 publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
