Thingiverse
Hex bit holder (bite teeth)
von michaelbourque
1.4k
Downloads
1.6k
Likes
2
Makes
Hex bit holder as dentures.
I designed and 3d printed this clever storage device for all my hex bits. I use 8mm magnets.
Go ahead and laugh but this is very useful and I’m thinking of other features I could add. Suggestions welcome.
Designed in Creo Parametric and printed in ASA in CR-6 SE.
I designed and 3d printed this clever storage device for all my hex bits. I use 8mm magnets.
Go ahead and laugh but this is very useful and I’m thinking of other features I could add. Suggestions welcome.
Designed in Creo Parametric and printed in ASA in CR-6 SE.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!