Hex "Cap" to cover hex-map - no interlink

A hexagon, designed with a "lip" and inset to serve as a cap to the pieces on a popular boardgame. The piece was requested to not have interlocking components for ease of placement after a board has been constructed.

When establishing the settings in your 3d printing software use the following to get the SCALE correct:
X = 254%
Y = 233%
Z = 70%

If you want a tighter fit, drop the X to 251, and Y to 233. It should "snap" into place at this size.

It is suggested to "flip" the model so that it's resting on the largest side for best results.