Thingiverse
hex nut M3 standoff
von gregor_p
226
Downloads
121
Likes
1
Makes
Designed to be used as PCB standoff when building a quadrocopter, but obviously, it can be used in any PCB or other application. Should accept a M3 screws without any problem.
NOTE: I tested a 8mm version printed with eSun ePA (nylon) filament and apart from small stringing it went out great and 100% usable.
NOTE: I tested a 8mm version printed with eSun ePA (nylon) filament and apart from small stringing it went out great and 100% usable.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
