Thingiverse
Hex Organizer
door Smokeshow81
2
Downloads
1
Likes
0
Makes
I designed this from scratch but the idea was based off the Cable Management Hive. I had two goals.
1. Increase the size of the Hex(Roughly 50 mm from wall to wall)
2. Create it in such a way that it could be printed in Spiralize Outer Contour.(cura). "Vase Mode"
It took a few versions before I could get the lines close enough that they could bond together.
This is designed for a .4 nozzle. It's a fairly large print at 200x188x90 but should fit most machines. I would advise against scaling it up on either the x or y because it will increase the gaps between the hexs and it won't keeps it's rigidity.
1. Increase the size of the Hex(Roughly 50 mm from wall to wall)
2. Create it in such a way that it could be printed in Spiralize Outer Contour.(cura). "Vase Mode"
It took a few versions before I could get the lines close enough that they could bond together.
This is designed for a .4 nozzle. It's a fairly large print at 200x188x90 but should fit most machines. I would advise against scaling it up on either the x or y because it will increase the gaps between the hexs and it won't keeps it's rigidity.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
