MakerWorld
Organizers
Zum Modell
Hex Screwdriver Desk Mount
0
Downloads
0
Likes
0
Makes
I printed mr.maxproof's Hex Screw Drivers, which work great, but wanted a way to mount them to my desk near my printer, WALL•E. There are two versions of the mount, both of which have the through holes sized specifically for 1.5mm, 2mm, 2.5mm and 3mm in an effort to keep them in order, be it smallest to largest or larges to smallest, depending on the version used. With indentations on the back for use with double-sided adhesive pads. The adhesive pads I used are 20mm x 12mm x 2mm so the indent would allow for proper adhesion, but not make the mount stick out from the mounted surface. Using this mount would mean the orientation of the drivers would be, left to right, 1.5mm, 2mm, 2.5mm and 3mm.Without indentations on the back. Using this mount would allow for orientation of the drivers to be smallest to largest, or largest to smallest, personal preference.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!