Hexagonal Desk Orgainzer

I decided it was time to replace the old utensil holder that's been my pen/pencil holder for 20 years, and hexagons popped in my mind, so I drew this up and printed it.The walls are a little bit thick, but it prints clean and holds plenty of pens and such. There's a good bit of infill in it, but necessary to ensure the bottoms of the holders start properly. Throw some anti-slip rug tape on the bottom and it won't go anywhere. There are three plates in the profile:Plain PLA is just a regular print, but with a brim for Cool/Smooth plates.Coextrusion Silk PLA also has a brim enabled, but has the outer walls slowed down and a fun little pattern on the bottom of the tray.Plain PLA (tPEI) is the same as Plain PLA, but does not have the brim enabled as it's intended to print on a textured PEI plate where it would be unnecessary.I love the way co-extrusion filaments play with surface patterns!