Hexagonal Lamp

HardwareThe bulb is an LED. I would avoid bulbs that get hot.Switch2x 20mm M3Lamp Posts6x 12mm M3Socket screwThere is a separate hole for the lightbulb socket for a screw to go in, that i used to prevent the socket from falling out or spinning around.Lightbulb socketI cut off the spinning part of the socket that turns on the light and soldered my own switch in the power linePrint InfoThe posts were printed laying horizontallyYou can print a 159x54x1.8 mm flat square and remove top layers to do infill patterns if you'd like. I tested with honeycomb but my wife didn't like itThe diffuser is flexible enough to get into the slots without too much troubleI printed with 0.2mm layer lines(Optionally). I also put air dry clay inside the base to make it feel heavy. I've shared .step files so you can easily modify at will. Thanks for looking.