Thingiverse
Hexagonal Photo stand
door logic0905
1
Downloads
3
Likes
0
Makes
It was designed as a gift, intended to be printed on a Prusa XL and fit within its build volume.
Since it was printed from translucent filament, 100% infill was used. Does that help? I have no idea—but from a mechanical point of view, 3 perimeters and 15–20% infill should be sufficient.
At full scale, the holes are 3 mm in diameter.
Since it was printed from translucent filament, 100% infill was used. Does that help? I have no idea—but from a mechanical point of view, 3 perimeters and 15–20% infill should be sufficient.
At full scale, the holes are 3 mm in diameter.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
