Hexcomb Shoe Rack Design

Print the two side panels. I went with 40 % infill and they turned outvery sturdy.Supports may be needed, depending on your printers bridging quality.Cut to length six rods or tubes of 20 mm diameter.Through 4 of the six rods, drill parallel holes of 3.5 mm diameter,offset 4.5 mm from each end.Place hex nuts into the slots in the side panels.Place the 4 rods with holes in the outer slots in the side panel andsecure with the M3 bolts.Place the remaing two tubes i the center slots.Fix the second panel to the other side of the rods in the same way.