Thingiverse
HHO Generator (Dry Cell)
por cEMa
54
Descargas
35
Likes
0
Makes
(This Is A Rough Draft)
I've reviewed many HHO Generator designs and have found many to be over complicated and difficult to make. I've decided to follow upon a specific design to allow minimal print times with high tolerances and safety precautions (flashback arrest).
This is a work in progress as I am still undergoing the development of the initial prototype. The goal is to have the entire unit 3d printable, excluding the hose and steel plates.
When Complete you'll have/need the following
- 4" HHO Dry Cell Generator
- 1x Flashback Arrestor
- X number of steel plates (as desired)
- Printed Gaskets for separating plates
- Plastic Screws and Nuts (3d printed)
- Hose Connectors (Barbed Connects)
- Hose
- Hypodermic Needle (for the torch)
I assume this will take approx 6 hours to complete.
I've reviewed many HHO Generator designs and have found many to be over complicated and difficult to make. I've decided to follow upon a specific design to allow minimal print times with high tolerances and safety precautions (flashback arrest).
This is a work in progress as I am still undergoing the development of the initial prototype. The goal is to have the entire unit 3d printable, excluding the hose and steel plates.
When Complete you'll have/need the following
- 4" HHO Dry Cell Generator
- 1x Flashback Arrestor
- X number of steel plates (as desired)
- Printed Gaskets for separating plates
- Plastic Screws and Nuts (3d printed)
- Hose Connectors (Barbed Connects)
- Hose
- Hypodermic Needle (for the torch)
I assume this will take approx 6 hours to complete.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!