Thingiverse
Hi-Vis DiiiCooler
di 3DDOC
240
Download
86
Likes
5
Makes
This version of the very popular fan shroud allows for a Clear View of the Nozzle through a Large View Port. It was Remixed in response to Demand for Better Visibility of the Nozzle while maintaining the original design as much as possible.
However, this comes at the Cost of 2 Vents Openings. But, the Round View Port does allow airflow over the opening and out of the remaining Vent beyond it.
This was designed with users that find it very important to be able to visually inspect the nozzle during a print job in mind. You may also use it if you simply find your nozzle sexy and want to stare at it for hours as it prints (Just don't tell us about it, please).
In Action: https://www.youtube.com/watch?v=RDug9pcPspQ
Please remember that a PID Autotune is highly recommended post-Installation the directions for which can be found at: http://3dprinterwiki.info/wiki/wanhao-duplicator-i3/duplicator-i3-calibration/extruder-pid-tuning/
HARDWARE (Same as Original)=
•1 x (M4x20) Screw
However, this comes at the Cost of 2 Vents Openings. But, the Round View Port does allow airflow over the opening and out of the remaining Vent beyond it.
This was designed with users that find it very important to be able to visually inspect the nozzle during a print job in mind. You may also use it if you simply find your nozzle sexy and want to stare at it for hours as it prints (Just don't tell us about it, please).
In Action: https://www.youtube.com/watch?v=RDug9pcPspQ
Please remember that a PID Autotune is highly recommended post-Installation the directions for which can be found at: http://3dprinterwiki.info/wiki/wanhao-duplicator-i3/duplicator-i3-calibration/extruder-pid-tuning/
HARDWARE (Same as Original)=
•1 x (M4x20) Screw
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
