Hictop Inductive Sensor Holder

I made this just to test out my sensor i also put the picture of the lm7 5v 1.0amp regulator to show you how it is installed

remember the brown wire constant 12v use the power that powers your board

connect the output of the sensor, which should be black to the input end of the regulator lm7 5v 1.0amp

solider a ground wire from the ground on the regulator which is the middle pin.
soldier a output wire to the out put pin on the regulator

now connect the out put wire to the vcc+ on the -zmin which is shown red in the picture
now connect the ground to the ground pin which is show in the picture