Slicer Discord
HiFiBerry DAC+ Zero Pi Zero W Case – Modelo 3D imprimible de Thingiverse Thingiverse

HiFiBerry DAC+ Zero Pi Zero W Case

por skyform
44 Descargas
22 Likes
0 Makes
Ver Modelo
Case for a Pi Zero W with a Hifiberry Dac+ Zero, as well as an option for a soldered on 3.5mm audio jack on the Dac+ Zero (see pictures-white one has jack).

I included a version that uses M3 2-3mm screws to hold down the pi, but note these are a very tight fit in the holes of the pi itself. ***Go slowly to avoid cracking the Pi***. The holes in the STL are 2.8mm.

This is designed to fit a **Pi Zero w 1.3**, which requires a millimeter or so of extra space for the camera connector. **It will also fit previous versions** without the camera connector.

**NOTE:** Take the SD card out when installing/removing the Pi. Once the Pi is in the case, it is very difficult to remove with the DAC attached because the USB port gets stuck. I may change this in a future version (let me know if you want the change!)

Also-this case is a really really tight fit. I still need to modify the 3.5mm jack model because, as you can see from the picture, it cracked upon install.
---

###**What ca
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

1 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección