Hikoki C10RJ - zero clearance insert

Zero clearance insert / throat plate for the Hikoki / Hitachi / Metabo C10RJ table saw / contractor saw.To connect the two halves you have to use 6 metal rods with a diameter of 4mm and a length of 90 mm. These will also add some rigidity to the insert. What you need besides the print:6 metal rods with a diameter of 4mm and a length of 90mm4 Threaded pins - M5 - length 10mm ca glue (although I didn't end up using it) Assembly:After printing, drill out the holes with a 4mm drill bit, make sure not to go deeper than 48mm (the total depth of the hole is 50mm).Sand the edges of the 2 halves that will connect. Best way to do it is by using a sander with a guiderail or plate, that ensures you can sand at a 90 degree angle to the topside.Mark the rods at 45mm (so you know how far to insert them).Insert the rods in one half, the rods I used are a bit larger in diameter than the drill bit I used, so the fit was very snug and I needed to use a hammer to tap them in.If the rods go in easily,