Hinge with 75 degree backstop
von leothehuman
12
Downloads
12
Likes
0
Makes
This is a top cover hinge for a RailCore printer with a 75 degree backstop. It should hold the top cover at a comfortable angle where it does not close on its own and doesn't hit the wall behind the printer if you have some gap there. I haven't tested this exact hinge (mine is 80 degrees and it's barely enough tilt back). I use it with the back plates on both the lid and the frame side: https://www.thingiverse.com/thing:3745992
Warning: This might actually put some undesirable load on the acrylic, I haven't used it long enough to tell if there's any undesired effects. I plan on re-designing it in the future to extend to the extrusion and have a backplate that attaches to the extrusion on the bottom, but for now that will do for me.
Warning: This might actually put some undesirable load on the acrylic, I haven't used it long enough to tell if there's any undesired effects. I plan on re-designing it in the future to extend to the extrusion and have a backplate that attaches to the extrusion on the bottom, but for now that will do for me.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
