MakerWorld
Other Toys & Games
Zum Modell
Hinged Deck Box - Magic: The Gathering
172
Downloads
32
Likes
90
Makes
I adapted the model from tjdesign on Printables by adding the Logo on the lid.In Bambu Studio simple use the paint tool to fill in the logo area. Box Size: 100mm x 68mm x 54mm The model uses 6x2mm magents that are simply glued in place after printing. Hinge Instructions:Slide a piece of filament through the hinge leaving about 1-2mm of excess on each side. Use a flame/heat source to warm the end (1-2seconds max) and then press the hot plastic against a flat surface, locking the hinge into place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
