Hinged Pipe Clamp

Print-in-place hinged pipe clamp uses 3d printed screws and nuts. Clamps onto pipe diameters from about 29.5mm to 35mm.(Think broomstick) Should be able to scale this to some degree, but that has not been tested. Hinge clearances are 0.4mm.Screws will easily shear if overtightened. Locking nuts provided to avoid loosening. You can use actual screws and nuts if desired. A ¼-20 bolt will fit through the provided roll nut (use 2) and works well. But again, don't overtighten. This was a sub-assembly of another project, thought I might share it because I haven't seen anything similar out there.3 Versions (separate print profiles)Standard Pipe Clamp (purple, shown with ¼-20 screws and nuts)Pipe Clamp - Horizontal Hook (yellow)Pipe Clamp - Vertical Hook (green)Version History6/30/2025 - Original release. Boost MeThere are 10 types of people in this world, those that understand binary, and those that don't.