Thingiverse
Hinges & Handle
von Dongwookim
88
Downloads
58
Likes
1
Makes
Hinges & Handle
I used PLA with it.
printed with no support and no raft
(Hinges printed on layer 0.3 mm and Handle printed on layer 0.2 mm)
I's design it for use with my 3Dprinter!
I used PLA with it.
printed with no support and no raft
(Hinges printed on layer 0.3 mm and Handle printed on layer 0.2 mm)
I's design it for use with my 3Dprinter!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
