Thingiverse
Hip Flask Funnel
door gavmeister
1
Downloads
4
Likes
0
Makes
I lost the little funnel for filling up my hip flask, so this one is sized for a small hip flask.
The funnel bit is just less than 10mm, and the top bit is 30 mm wide.
There are 2 models here, one with a straight funnel bit, and another with a gap to allow air to escape so it doesn't glug.
Print upside down with a brim and no supports.
The funnel bit is just less than 10mm, and the top bit is 30 mm wide.
There are 2 models here, one with a straight funnel bit, and another with a gap to allow air to escape so it doesn't glug.
Print upside down with a brim and no supports.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!