HITBOX promicro clone

Hitbox styled controller clone. Uses a pro micro to connect to pc. I do not know how to make this work with console, but it would require a brook board or some sort of firmware that would allow for arduinos to work as controllers on consoles, but it works well on PC. I used Haystack's code to emulate a joystick.

Required items:
16 MX switches
~200g of filament
1 Pro Micro
9 screws (3.5 mm holes)
Solid core wire/Copper wire
Soldering Iron

Optional but highly recommended:
9 M2 brass inserts (use a soldering iron to melt them into each hole/standoff max height 8 mm)
9 m2 screws


Very rough outline of a guide below. I'd recommend people be experienced with arduinos and soldering before attempting this without help.
---

Guide

1. Print main
2. Print bottom
3. While bottom is printing, solder all MX switches with a common ground (don't attach to pro micro yet)
4. After daisy chaining the switches (any leg works) cut out wires for individual pins to be connected to