Thingiverse
HK paddle jig
door death4u
34
Downloads
20
Likes
0
Makes
This is an improved 1 piece jig for drilling the hole for installing a paddle release. I modeled it to fit tightly onto the Century C93 receiver.
It is a snug fit and will require a rubber mallet to fully install the jig on the receiver. Once it is on all they way insert the pin. Drill the hole from one side with an 1/8" bit. From the same hole spot drill a blind hole on the other side. Only drill the hole about 1/16" deep.
The jig should also work with other Century HK clones, but I'm not able to test it.
The Fusion 360 file is included.
It is a snug fit and will require a rubber mallet to fully install the jig on the receiver. Once it is on all they way insert the pin. Drill the hole from one side with an 1/8" bit. From the same hole spot drill a blind hole on the other side. Only drill the hole about 1/16" deep.
The jig should also work with other Century HK clones, but I'm not able to test it.
The Fusion 360 file is included.
death4u publiceert ook op
124 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!