Thingiverse
HK3000 RX Case
von vegos
1
Downloads
0
Likes
0
Makes
I had my HK3000 RX enclosure broken, so I design one.
Printed with PETG, 0.2mm layer height, 0.8 shell thickness, 0.8 top/bottom thickness.
It fits perfectly the rx board with no play inside.
It just needs some CA to glue the bottom lid.
Printed with PETG, 0.2mm layer height, 0.8 shell thickness, 0.8 top/bottom thickness.
It fits perfectly the rx board with no play inside.
It just needs some CA to glue the bottom lid.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!