Thingiverse
Hobby Knife slider replacement - Complex small part
von eried
5
Downloads
7
Likes
0
Makes
I was wondering if a small complex part would be feasible in simple PLA... and it is. This replaces the typical slider piece of a hobby knife, those that use 18 mm width blades. The lock works and it is quite smooth to use in general.
Use CA (super glue) to join the 5 pieces as shown in the animation. It is easier if you have activator spray for the glue.
Use CA (super glue) to join the 5 pieces as shown in the animation. It is easier if you have activator spray for the glue.
eried veröffentlicht auch auf
130 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
