Thingiverse
Hobie 16 adjustable wind indicator
von Pistolsforpandas
2
Downloads
7
Likes
0
Makes
Untested yet.
I had issues with the angle of the indicator being wrong (therefore bias) after tensioning up the jib, so I made this one to adjust to level after tensioning the jib.
Uses 1/4" nuts & bolts to attach to chain-plate upside down (See remixed post) & arms together
Recommend using ASA for long term use, but PLA/PETG should work for a season or two.
Put a Nylon washer (Or just cut up a credit card and drill a 8mm hole into it) between the indicator & screw.
Salt water gets between the parts and dries out causing friction, so you have to wash it somewhat often.
I had issues with the angle of the indicator being wrong (therefore bias) after tensioning up the jib, so I made this one to adjust to level after tensioning the jib.
Uses 1/4" nuts & bolts to attach to chain-plate upside down (See remixed post) & arms together
Recommend using ASA for long term use, but PLA/PETG should work for a season or two.
Put a Nylon washer (Or just cut up a credit card and drill a 8mm hole into it) between the indicator & screw.
Salt water gets between the parts and dries out causing friction, so you have to wash it somewhat often.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
