Thingiverse
Hold a door open
door tynbendad
35
Downloads
43
Likes
0
Makes
Door holder to keep a door open a few inches (small enough that a cat can't get in = short stl) or several inches (just large enough for a cat to squeeze in = long stl).
Sized for our door width (~35mm) and latch/striker plates (schlage, indoor).
Printed in a stiffer TPU (harder than ninjaflex), but PLA might work if you're careful about inserting it in the striker plate opening. No supports needed, prints flat on the plate, quick and easy print.
Sized for our door width (~35mm) and latch/striker plates (schlage, indoor).
Printed in a stiffer TPU (harder than ninjaflex), but PLA might work if you're careful about inserting it in the striker plate opening. No supports needed, prints flat on the plate, quick and easy print.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
