Thingiverse
Holder for idle knob
von lastand
7
Downloads
4
Likes
0
Makes
CBR 1000 RR 04-07 SC57
The idler knob is supported with this rotating fork, as seen in the picture. Original and Copy seen on the other picture.
It take a good twist to make it loose after print. Only did one prototype, that worked great.
EDIT: Don't use PLA for this. it get´s too hot at the position of the holder.
The idler knob is supported with this rotating fork, as seen in the picture. Original and Copy seen on the other picture.
It take a good twist to make it loose after print. Only did one prototype, that worked great.
EDIT: Don't use PLA for this. it get´s too hot at the position of the holder.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!