Holder for Type 2 EV cable

All models I have seen so far are female plugs: you are supposed to plug your cable onto the wall as you would to into the car.
Problem is that it needs to be horizontal then (else, either it is too tight, and risk to damage the cable, or it falls). And that takes a lot of room. Plus I prefer to have a bit of the load on the handle rather than on the plug itself (I know: when plugged to the car, all the load is on the plug. But then the angle is even higher than horizontal, and the plastic of the car plug is less hard)

So I wanted to have something easy to use, that put the load on the handle, that allows quasi vertical angle of the cable, and that close the connector (it is in my garage, which is not very tidy. I don't want to discover that a small spider started to make a cocoon inside the connector one day...).

That model does all that. You don't really have to plug the cable on the support. More lay it. But yet the support is shaped for the cable, such has it perfectly fit