Thingiverse
Holder IEC Secure Enclosure
von Sheo_888
2
Downloads
1
Likes
0
Makes
I developed this because once my cat was able to disconnect the cables if you know the normal name of this project write in the comments I printed petg with plastic on the FlyingBear Ghost 5 printer
to connect I used:
2 or 1 nut m3
1 screw m3 40 mm long
1 screw m3 25 mm long
to connect I used:
2 or 1 nut m3
1 screw m3 40 mm long
1 screw m3 25 mm long
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
