Thingiverse
Hole Plug 30 mm
di Ashak1el
8
Download
12
Likes
0
Makes
The plug is designed to cover holes made with a 30 mm pin drill.
The wall of the model is 0.7 mm. I print with a nozzle of 0.4 mm with a line width of 0.4 mm. Printing takes place in 2 walls.
In vase mode, I select the width of the lines - 0.6 mm. Both options work in my case. But in vase mode, you can only print 1 cap at a time.
By scaling the model along the x and y axes, I think it is possible to select the desired values for other hole diameters.
Model in .f3d format attached
The outer diameter of the plug legs according to the project is 31 mm. The plugs I printed fit into the holes quite tightly. Perhaps it makes sense to reduce the scale of the x and y axes by 1-1.5%, but again in my case everything fell into place.
The wall of the model is 0.7 mm. I print with a nozzle of 0.4 mm with a line width of 0.4 mm. Printing takes place in 2 walls.
In vase mode, I select the width of the lines - 0.6 mm. Both options work in my case. But in vase mode, you can only print 1 cap at a time.
By scaling the model along the x and y axes, I think it is possible to select the desired values for other hole diameters.
Model in .f3d format attached
The outer diameter of the plug legs according to the project is 31 mm. The plugs I printed fit into the holes quite tightly. Perhaps it makes sense to reduce the scale of the x and y axes by 1-1.5%, but again in my case everything fell into place.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!