Thingiverse
Holey Trash Can
door kenjijones
46
Downloads
56
Likes
0
Makes
This is a trash can full of holes so you're forced to use a trashbag with it... or not.
The diameter of the top is roughly 200mm... a little more with the lid.
On the contrary there is a non holey version that can be used to print in vase mode. I would recommend using PETG or else it will be very brittle, but still usable.
The vase model printed in less than 4 hours using the draft setting 0.3mm layer thickness in vase mode. I used Fusion360 and Prusa slicer to design these.
PRINTING THE LID: print it upside down so you don't need supports.
The diameter of the top is roughly 200mm... a little more with the lid.
On the contrary there is a non holey version that can be used to print in vase mode. I would recommend using PETG or else it will be very brittle, but still usable.
The vase model printed in less than 4 hours using the draft setting 0.3mm layer thickness in vase mode. I used Fusion360 and Prusa slicer to design these.
PRINTING THE LID: print it upside down so you don't need supports.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
