Hollow Knight

My first manifold model intended for resin printing. I didn't split the stl but I recommend supporting anyways with the bottom of head, top of the cape, and sword facing down. recommend printing at 200 percent plus (I apologize, I'm not good at scaling) and Sword should be doable with a few light supports.

Support the bottom of the head and top of the cape however you want, they were made with the intention to be sanded flat so it shouldn't affect the quality of the model any.

Let me know what you think or if you have any issues. I attached a picture of the way I supported it somewhere below (this is literally my first post I don't know where it shows up)