Thingiverse
Hollowed out
von jhenager1
61
Downloads
41
Likes
0
Makes
100% infill is needed to make it sink. It is going into the aquarium.
I didn't do the best job on hollowing, as I forgot to flip one part before extruding it. But there are no overhangs.
I didn't do the best job on hollowing, as I forgot to flip one part before extruding it. But there are no overhangs.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!