HoloLens Spectator View Mount

For more information and background, please read: http://www.thetylergibson.com/improving-spectator-view-a-usable-hololens-mount Amazon wishlist for all the optional goodies that make life easy with this mount: https://www.amazon.com/gp/registry/wishlist/2CVA3M6A6YEED/ref=cm_wl_list_o_3 Three mounting options All three of the brackets are 3D Printable on most consumer 3D Printers. With a build volume of just under 200mm95mm75mm, and two of the three are designed to print without any supports. The center mount point is positioned at the HoloLens’ center of gravity at a height offset that should fit nearly every DSLR camera on the market today. You will only need to remove the nose-piece before installing any of the mounts. You will need to drill each screw hole out to size after printing. I did this to enable you to use M5 machine screws if desired, or drill out to use 1/4”-20 screws. I used a #3 drill bit with very good results, but you should measure twice and drill once. I highly rec