HoloLens Spectator View Mount

For more information and background, please read:
http://www.thetylergibson.com/improving-spectator-view-a-usable-hololens-mount

Amazon wishlist for all the optional goodies that make life easy with this mount:
https://www.amazon.com/gp/registry/wishlist/2CVA3M6A6YEED/ref=cm_wl_list_o_3

### Three mounting options
All three of the brackets are 3D Printable on most consumer 3D Printers. With a build volume of just under 200mm*95mm*75mm, and two of the three are designed to print without any supports.
The center mount point is positioned at the HoloLens’ center of gravity at a height offset that should fit nearly every DSLR camera on the market today.
You will only need to remove the nose-piece before installing any of the mounts. You will need to drill each screw hole out to size after printing. I did this to enable you to use M5 machine screws if desired, or drill out to use 1/4”-20 screws. I used a #3 drill bit with very good results, but you should measure twice and dri