Thingiverse
Holster Clips
by Asmith987
8
Downloads
6
Likes
0
Makes
Recommend printing in upright orientation (extraClip is the only one not already in this orientation), with largest nozzle and highest layer height for maximum strength.
No support should be needed, however to prevent bed separation, I have found success using a raft.
PLA to make sure part fits your holster, then use high strength high temp material to prevent warpage/breakage when in use.
May need to use side cuts to separate angled clip from mounting base.
Good for replacements, or for lowering current holster height.
No support should be needed, however to prevent bed separation, I have found success using a raft.
PLA to make sure part fits your holster, then use high strength high temp material to prevent warpage/breakage when in use.
May need to use side cuts to separate angled clip from mounting base.
Good for replacements, or for lowering current holster height.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!