Home Assistant Case

An enclosure for my Raspberry Pi 3 Model B based Home Assistant.

This is a two-piece case with no fasteners. The top half friction fits to the bottom half. Plenty of holes in both halves provide good ventilation. My wife cut the vinyl sticker for me on her Cricut machine.

The only exposed R-Pi ports are the SD card and USB power. I used an RJ45 keystone jack to route the Ethernet connector to the same side as the USB port. This allows me to unplug the Ethernet without opening the enclosure, plus both cables hang off the shelf from the same side of the box. Probably not necessary, but I had it laying around.

The XBee module is a Digi Zigbee radio mounted on a SparkFun XBee Explorer. The USB stick is a Zooz Z-Wave radio (removed from the plastic cover).

https://hub.digi.com/support/products/digi-xbee/digi-xbee-s2c/
https://www.sparkfun.com/products/11812
https://www.thesmartesthouse.com/collections/zooz/products/zooz-usb-700-series-z-wave-plus-s2-stick-zst10-700

The phot