HOMEMADE HOG STRETCHER

This is an old version of the Hog Stretcher.
Find the latest Hog Stretcher pre-made at https://HonestPE.etsy.com/

Print settings:

Use 0.12mm layer height for the ruler/bearing piece so that the markings will be visible. Use arachne mode as well so that it will be the correct thickness. After printing, rapidly move this piece up and down the rod to wear down/remove any irregularities and ensure smooth motion.

Here is a complete list of the parts you will need:

mcmaster:
316 Stainless Steel Corrosion-Resistant Compression Springs x2 ($8.82 for 2)
https://www.mcmaster.com/8969T811/
Passivated 18-8 Stainless Steel Pan Head Phillips Screws x2 ($6.68 for 10-pack)
https://www.mcmaster.com/92000A526/
Tapered Heat-Set Inserts for Plastic x2 ($13.06 for 10-pack)
https://www.mcmaster.com/94180A386/
amazon:
Gas Spring End Fitting M6 Female Thread 8mm Hole ($11 for 2-pack)
https://www.amazon.com/dp/B09B7G1QRY
Threaded Heat-Set Inserts Brass for Printed Plastic