Homeracker Skadis interface

This generator generates brackets to mount onto your existing homeracker racks. The minimum units is 4 - this translates to 6cm, meaning two skadis pegs.The next larger size is 7 units for three pegs but you can print other sizes too, check the configurator. I have not yet tested the Z bracket yet. One axis per plate, each plate as 4 and 7 units sized. Add brim if your bed adhesion sucks. You can mirror the results in bambu studio or whatever else software to get almost all orientations. Not a super sturdy mount but great for smaller, printed skadis boards. Board in the photo is a1m size and also coincidentally 12 homeracker units. offset by 4 units to get both sides held. Homeracker can be found herehttps://makerworld.com/en/models/1317298-homeracker-modular-rack-building-system#profileId-1352703