MakerWorld
Office
Zum Modell
Hook and Loop Snap Connector
17
Downloads
4
Likes
8
Makes
I got frustrated with the regular Underware not holding my insane amount of cables under my desk and made a little hook and loop snap connector. Uses the original base with a 14x2mm opening. I bought a whole roll of hook and loop off amazon but had to cut it in half length ways to make it work. Take it out of the multiboard by putting some hook and loop through and pull.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!