Thingiverse
Hook Door Stop
por josolanes
2
Descargas
0
Likes
0
Makes
This is my design for a simple door stop that hooks over a spring door stop and under the door to keep the door in place.
I printed at 0.20 resolution and 30% infill, but I'm sure these can be adjusted as needed. With these settings they'll print in about an hour and is easy to print. Print as shown and no supports are needed.
I uploaded 2 variations of it:
- DoorHolder.stl works well for our interior doors
- DoorHolder-Exterior.stl works well for our exterior doors, which are thicker than the interior ones
To install them, slide them under the door and hook it over the spring door stop. They should hold the door well and put up with some abuse even in PLA. I've accidentally pulled a door pretty hard not realizing they were on without damage to the print or door.
I printed at 0.20 resolution and 30% infill, but I'm sure these can be adjusted as needed. With these settings they'll print in about an hour and is easy to print. Print as shown and no supports are needed.
I uploaded 2 variations of it:
- DoorHolder.stl works well for our interior doors
- DoorHolder-Exterior.stl works well for our exterior doors, which are thicker than the interior ones
To install them, slide them under the door and hook it over the spring door stop. They should hold the door well and put up with some abuse even in PLA. I've accidentally pulled a door pretty hard not realizing they were on without damage to the print or door.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
