Hook for EasyRig Stabil

This hook is designed to slot onto the back of the EasyRig Stabil arm, allowing you to hook the EasyRig onto magliners, tree branches, gates, and a wide range of things. This way, you don't have to lay it on the ground when not in use.

Print with the flattest side against the bed, use supports.

The hook is made of two halves so that it can be printed laying flat with minimal supports. This way it's very strong and isn't going to snap.

Print with 4 walls and 25% triangular infill with double lines. Should print within 6-7 hours and still be very strong.

You need two M5 bolts and locknuts to secure the two halves together.
You also need four strong zip ties to secure the hook to the EasyRig.