Thingiverse
Hook
von jnguiot
1
Downloads
10
Likes
0
Makes
Just a nice hook to put on a wall with a screw.
Best is to print it on the side. Strength will come from top and bottom layer, not infill. To increase strength, best it to increase top and bottom
Best is to print it on the side. Strength will come from top and bottom layer, not infill. To increase strength, best it to increase top and bottom
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
