Hopcorn

Hippity hoppity poppity! Here comes Hopcorn! There are two boxes and tops. The clicker top is a little tricky - if it's not lined up the top will get stuck a little, I put a little dot to help with orientation. You can remove the dot to save on purging, just remember how it came off the bed.  115% box size will fit two bunnies and the clicker.  The grooved box is for those who like to hand paint. One of the tops is hollowed out so you could make the box smaller or if you don't like the flat bottom top. Painted 3mf included. Start a new project before opening the 3mf. Verify settings; what works for me may not necessarily be the correct setting for your printer. Verify flushing volumes. Printing recommendations:  .20 layer heightPrint in place, no support required3 walls - 15% infillAllow the plate to cool before removing the printsReduce acceleration and adjust overhang speeds as needed Filaments:  Protopasta - Moonstruck White Satin Protopasta - Flekn' Fire Red Protopasta -