Thingiverse
Hops Tap Handle (3/8"-16 Thread)
door TheFlyingCaveman
396
Downloads
185
Likes
11
Makes
First things first: this was inspired by [this tap handle](https://www.thingiverse.com/thing:1286779) and it was created in [OnShape](https://www.onshape.com/) before I realized that the other model included the part file...
This model is different because:
* It does not require any support material
* There is just enough threading to allow for stability while tightly fitting to a 3/8" screw
* It requires less material as it is thinner (20% infill gives it more than enough strength)
* The fillets on the top and bottom are of different radii to allow for a different finished look
The current stl is threaded for a 3/8"-16 Tap.
This model is different because:
* It does not require any support material
* There is just enough threading to allow for stability while tightly fitting to a 3/8" screw
* It requires less material as it is thinner (20% infill gives it more than enough strength)
* The fillets on the top and bottom are of different radii to allow for a different finished look
The current stl is threaded for a 3/8"-16 Tap.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!