Hori Mini DPad Replacement

**This is a replacement DPad for the Retrobit Hori Mini n64 controller, which should lower the risk of mispressing the dpad buttons.**



**Brief Guide for Replacement. It's very important that you do this on a clean workspace**
-Remove the six screws on the back of the controller, it's preferable to put these on a magnet of some sort to make sure you don't lose any.
-Carefully remove the back panel and place to the side.
-Remove two screws from the back of the joystick, make note that these screws should be much shorter than the others for reassembly.

-*Carefully remove the following:*
+Both board units from the shoulder slots by grabbing the sides of the boards.
+Both shoulder buttons, set these to the side.
+The cables stop from the top of the controller.
+Finally the whole board assembly by grabbing the edges, gently pushing up on the control stick to avoid strain on any cables.

**At this point, leave the front face of the controller facing down, otherwise all of y