Thingiverse
Horizontal Dust Separator
by iporty
111
Downloads
92
Likes
0
Makes
Horizontal dust separator.
The parts all bolt together with 1/4 20 bolts.
The outlets on the bottom need to go into a sealed chamber. The air should not blow out of them, the material should just fall out.
Still lots of testing to do.
The prints are fairly large. I have a 280mm x 280mm print bed. You could probably thin some of the flange without causing problems.
Fusion File
https://a360.co/372ZY3s
YT Video of construction (not me)
https://www.youtube.com/watch?v=eTldQA6YegY
The parts all bolt together with 1/4 20 bolts.
The outlets on the bottom need to go into a sealed chamber. The air should not blow out of them, the material should just fall out.
Still lots of testing to do.
The prints are fairly large. I have a 280mm x 280mm print bed. You could probably thin some of the flange without causing problems.
Fusion File
https://a360.co/372ZY3s
YT Video of construction (not me)
https://www.youtube.com/watch?v=eTldQA6YegY
iporty also publishes on
22 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!