Thingiverse
Horizontal Magsafe Charger
von ToMMzi
6
Downloads
2
Likes
0
Makes
Hello!
This is my first 3d design.
I designed a small, elegant and easy to print magsafe charger that uses the Standby mode on iOS 17.
I used double sided sticky tape to tape the magsafe charger to the stand and it works great.
If you have any suggestions on what to improve then leave a comment.
This is my first 3d design.
I designed a small, elegant and easy to print magsafe charger that uses the Standby mode on iOS 17.
I used double sided sticky tape to tape the magsafe charger to the stand and it works great.
If you have any suggestions on what to improve then leave a comment.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!