Thingiverse
Horizontal Spool Holder
von Argento9899
4
Downloads
3
Likes
0
Makes
Horizontal spool holder, it works with any spool that has the hole between 7/8cm in diameter
The pieces were printed with 10% infill, 0.3mm layer high in PLA.
Only the "bottom.stl" piece requires support, I recommend a support overhang angle of 65%, do not leave the default angle or it can mess up the thread.
It requires more or less 15 6mm diameter ball bearings (softair plastic Bbs works too) that have to be placed inside the ring-shaped slot in the "base" piece, the "bottom" piece will slide on top of the spheres making a bearing-like structure.
The pieces were printed with 10% infill, 0.3mm layer high in PLA.
Only the "bottom.stl" piece requires support, I recommend a support overhang angle of 65%, do not leave the default angle or it can mess up the thread.
It requires more or less 15 6mm diameter ball bearings (softair plastic Bbs works too) that have to be placed inside the ring-shaped slot in the "base" piece, the "bottom" piece will slide on top of the spheres making a bearing-like structure.
Argento9899 veröffentlicht auch auf
2 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
