Horizontal surface LoRa antenna bracket

The bracket should work with any 19mm base antenna - it was designed for and used with 60cm tall antenna made by Seeed Studio.

The base is screwed into flat surface with 2 or 3 screws, collar slides onto antenna, squeeze it a bit with your fingers and it should slide into the stand just fine.
In case your printer traces over center of line you will have half nozzle width overflows and it may get too tight. You may need to file down the lug holes in the stand. I suggest you file inside part - if you file outer wall, the collar may be too loose once attached to the stand and antenna will be sliding through it.